TAPER LENGTH DRILLS - FRACTIONAL SIZES
Taper Length Drill - High Speed Steel
page 78
For general purpose drilling where a longer than jobbers length drill is required.
Taper Length Drill - Cobalt
page 82
For heavy duty drilling in tough alloy steels, forgings, and casting.
Taper Length Drill - Heavy Duty
page 84
For deep hole drilling in hard steels, stainless steels, and other hard materials. Mfr. to NAS 907-B specs.
Taper Length Drill - Parabolic Flute
page 84
For deep hole drilling in a wide range of materials especially aluminum and mild
steel. Parabolic flutes ease chip ejection. These drills are also known as Worm Pattern Drills.
Taper Length Drill - Automotive (Tang)
page 86
For applications where a longer than jobbers length drill is required. The tanged
shanks are for use with positive drive split sleeve drivers.
Taper Length Drill - Fast Spiral
page 87
For deep hole drilling low tensile strength materials such as aluminum, magnesium, copper, zinc, and similar materials producing long stringy swarf. Excellent chip-clearing.
TAPER LENGTH DRILLS - METRIC SIZES
1mm to 14.25mm
page 80
14.5mm to 38mm
page 81
For general purpose drilling where a longer than jobbers length drill is required.
TAPER LENGTH DRILLS - WIRE GAUGE SIZES
Taper Length Drill - High Speed Steel
page 79
For general purpose drilling where a longer than jobbers length drill is required.
Taper Length Drill - Cobalt
page 83
For heavy duty drilling in tough alloy steels, forgings, and casting.
Taper Length Drill - Automotive (Tang)
page 86
For applications where a longer than jobbers length drill is required. The tanged shanks are for use with positive drive split sleeve drivers.
TAPER LENGTH DRILLS - LETTER SIZES
Taper Length Drill - High Speed Steel
page 79
For general purpose drilling where a longer than jobbers length drill is required.
Taper Length Drill - Cobalt
page 83
For heavy duty drilling in tough alloy steels, forgings, and casting.
Taper Length Drill - Automotive (Tang)
page 87
For applications where a longer than jobbers length drill is required. The tanged shanks are for use with positive drive split sleeve drivers.
TAPER LENGTH DRILL SETS
16 pc Taper Length Drill Set
page 81
sizes: 33/64 to 3/4 by 64ths
16 pc Taper Length Drill Set
page 81
sizes: 49/64 to 1 by 64ths
26 pc Taper Length Drill Set
page 81
Letter sizes: A to Z
29 pc Taper Length Drill Set
page 81
sizes: 1/16 to 1/2 by 64ths
60 pc Taper Length Drill Set
page 81
Wire Gauge sizes: 1 to 60