annular cutters 1 inch - side-front view
Annular Cutters are designed to be used with magnetic base drills, drill presses, milling machines, etc. to drill large diameter holes quickly and efficiently. They have up to 12 cutting edges to cut around the hole, leaving only a center slug which pops out. Quality burr-free holes can be cut in a single pass, 3-5 times faster than conventional twist drills. They can also cut multiple (overlap) hole configurations as well as curved surfaces and interrupted cuts. Annular Cutters are also available in 3" and 4" cutting depths. Contact us for more information.
ANNULAR CUTTERS - 1" CUTTING DEPTH
360° view
FRACTIONAL SIZES
Annular Cutters - M2 - 1" Deep Cutting page 126
Annular Cutters are for general purpose cutting of steel plate, structural steel, steel pipe, etc.
Annular Cutters - Titanium Nitride Coated (TiN) - 1" Deep Cutting page 126
Titanium Nitride Coated Annular Cutters are for harder materials and extra wear. Run at 15 to 25% higher speeds for best results.
Annular Cutters - Titanium Carbonitride Coated (TiCN) - 1" Deep Cutting page 126
Titanium Carbonitride Coated Annular Cutters are for hard abrasive materials that are difficult to cut, such as cast iron and high silicon aluminum alloys.

METRIC SIZES
Annular Cutters - M2 - 1" Deep Cutting - Metric Sizes page 126A
Metric Annular Cutters are for general purpose cutting of steel plate, structural steel, steel pipe, etc.

PILOT PIN
Annular Cutters - Pilot Pin page 127
Annular Cutter Pilot Pins are for use with annular cutters.

ANNULAR CUTTERS - 2" CUTTING DEPTH
360° view
FRACTIONAL SIZES
Annular Cutters - M2 - 2" Deep Cutting page 126
Annular Cutters are for general purpose cutting of steel plate, structural steel, steel pipe, etc.
Annular Cutters - Titanium Nitride Coated - 2" Deep Cutting page 126
Titanium Nitride Coated Annular Cutters are for harder materials and extra wear. Run at 15 to 25% higher speeds for best results.
Annular Cutters - Titanium Carbonitride Coated - 2" Deep Cutting page 126
Titanium Carbonitride Coated Annular Cutters are for hard abrasive materials that are difficult to cut, such as cast iron and high silicon aluminum alloys.

METRIC SIZES
Annular Cutters - M2 - 2" Deep Cutting - Metric page 126a
Metric Annular Cutters are for general purpose cutting of steel plate, structural steel, steel pipe, etc.

PILOT PIN
Annular Cutters - Pilot Pin page 127
Annular Cutter Pilot Pins are for use with annular cutters.
ANNULAR CUTTER SETS (KITS)
6 PC Annular Cutter Set - 1" depth page 127
6 PC Annular Cutter Set - 2" depth page 127
10 PC Annular Cutter Set - 1" depth page 127
7 PC Annular Cutter Set - 1" Depth page 127